Wasp WPL 406 Bedienungsanleitung PDF herunterladen (Seite 63)

adjustment.

1. Decrease the right side print head pressure

adjustment knob setting 1 level per each

adjustment then print the label again to check if

wrinkle is gone.

2. If the right side print head adjustment knob

setting has been set to index 1 (the lowest

pressure index), please increase the left side

print head pressure.

3. If the left side print head adjustment knob

setting has been set to 5 (the highest pressure

index) the wrinkle can’t be avoid, please rotate

the both knobs back to setting 1 then rotate the

Z-axis mechanism adjustment knob clockwise

for a few degrees and print again for fine tune

the print head pressure distribution.

Note for step 3:

*Factory default setting - the Z-axis knob is

rotated counter clockwise to the end of thread.

*Turn the Z-axis mechanism adjustment knob

clockwise until you feel the knob touch the

mechanism for the first adjustment.

* If the wrinkle is still there, please turn the Z-axis

mechanism adjustment knob clockwise about

1/4 circle each time for adjustment

* If the winkled direction is change from "ˊ" to "

ˋ" by adjusting the Z-axis mechanism

adjustment knob, please turn the Z axis

mechanism adjustment knob counter clockwise

to avoid the wrinkle.

adjustment.

1. Decrease the left side print head pressure

adjustment knob setting 1 level per each

adjustment then print the label again to check if

wrinkle is gone.

2. If the left side print head adjustment knob level

has been set to index 1 (the lowest index),

please increase the right side print head

pressure.

Z axis mechanism

adjustment knob

1 2 ... 58 59 60 61 62 63 64 65

Keine Kommentare

Wasp WPL 406 Bedienungsanleitung Seite 63