Wasp WPL 406 Bedienungsanleitung PDF herunterladen (Seite 61)

The left side printout

position is incorrect

* Wrong label size setup.

* The parameter Shift X in LCD menu is

incorrect.

* Set the correct label size.

* Press [MENU]  [SELECT] x 3  [DOWN] x 5

 [SELECT] to fine tune the parameter of Shift

Missing printing on

the left or right side of

label

* Wrong label size setup. * Set the correct label size.

RTC time is incorrect

when reboot the

printer

* The battery has run down. * Check if there is a battery on the main board.

Multi interface board

doesn’t work

* The installation is incorrect.

* Check if the board is plugged in the right

connector.

Power and Error LEDs

are blinking fast

* Power switch OFF and ON too fast.

* Turn off the printer and wait all LEDs are dark,

and turn on the printer again.

Wrinkle Problem

* Printhead pressure is incorrect.

* Ribbon installation is incorrect.

* Media installation is incorrect.

* Print density is incorrect.

* Media feeding is incorrect.

* Please refer to the 5.2 chapter.

* Please set the suitable density to have good

print quality.

* Make sure the label guide touch the edge of the

media guide.

Gray line on the blank

label

* The printhaed is dirty.

* The platen roller is dirty.

* Clean the printhead.

* Clean the platen roller.

Irregular printing

* The printer is in Hex Dump mode.

* The RS-232 setting is incorrect.

* Turn off and on the printer to skip the dump

mode.

* Re-set the Rs-232 setting.

1 2 ... 56 57 58 59 60 61 62 63 64 65

Kommentare zu diesen Handbüchern

Keine Kommentare

Wasp WPL 406 Bedienungsanleitung Seite 61

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Wasp WPL 406