Wasp WLS9500 Bedienungsanleitung PDF herunterladen (Seite 23)

Scanning 2-5

Scanning in Hand-Held Mode

Install and program the scanner (see Setting Up the Scanner on page 1-4). For assistance, contact the local supplier or

Wasp Technologies.

To scan in hand-held mode:

1. Ensure all connections are secure. (See the host chapter for the scanner.)

2. Aim the scanner at the bar code.

3. Press the trigger.

Figure 2-2. Scanning in Hand-Held Mode

4. Upon successful decode, the scanner beeps and the LED turns green. (For more information about beeper and

LED definitions, see Table 2-1 and Table 2-2.)

Scan line lengths vary depending on the scan line width selected (see Scan Line Width on page 4-

8). A full scan line width is the default. Medium and short scan line widths are useful for scanning

menus or pick-lists.

Aiming

On a typical UPC 100% hold the scanner between contact and 19 inches from the symbol (see Decode Zone on page 2-

10). When scanning using a single-line scan mode, ensure the scan line crosses every bar and space of the symbol.

Figure 2-3. Acceptable and Incorrect Single-Line Aiming

Red A data transmission error or scanner malfunction occurred.

Table 2-2. Standard LED Definitions

LED Indication

Single-Line Mode Multi-Line Raster Mode

012345

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 188 189

Keine Kommentare

Wasp WLS9500 Bedienungsanleitung Seite 23