Wasp WaspLabeler +2D Bedienungsanleitung PDF herunterladen (Seite 114)

110

Wasp Labeler User Manual

3. Enter the beginning character in the Start at seed: field, then enter

how many characters you want to increase per a set number of

labels in the Step and Every fields. For example, the default

settings (shown in the screen shot above) sets the serialization to

start at letter A and increase one letter (step) every one label. So

each label will go up one level. Changing the Every field to 2 means

that the alpha serialization will increase one letter (step) every 2

labels.

4. By default the serialization continues past Z to AA, BB, etc.. If you

want to change this, select the Rollover after checkbox and enter a

value. After the entered value is reached (the default is Z), the

serialization will start over with the seed value.

5. If you set the labels to rollover after a set value and do not want

them to reset to the seed value, select the Reset after rollover

checkbox. Enter the value you want to restart at in the field

provided.

6. In the Serialization Configuration section, check the checkbox if

you want to do one of the following:

- increment the sequence with each new record in an external data

source, or

- resume the serialization where it left off at the next printing.

7. Click the Preview button to view how your serialization will look.

Below is an example of the Serialization Preview screen:

8. By default 100 samples are displayed. You can adjust this number

up or down using the Number of samples to display field arrows or

enter a sample number. Click the Refresh button to update the

samples with any changes you have made or Close to close the

Serialization Preview screen.

9. Click

on the

Serial Alpha

screen to save your changes.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 204 205

Keine Kommentare

Wasp WaspLabeler +2D Bedienungsanleitung Seite 114