Wasp CCD Scanner Bedienungsanleitung PDF herunterladen (Seite 16)

Trigger pressed

* Trigger with Delay

Begin

Trigger Pressed

* Trigger with 3 Sec. Delay

End

The 'CCD Scanning Control' configuration allows the user to customize how the

t rigger is to opera t e, the length of time in which the LEDs (i.e. the CCD

photodetectors) are on, and activates auto scanning. The Wasp CCD has seve n

(7) options to control this configura t i o n . Only one option can be enabled at a time.

Note: When the LEDs are visible, the CCD scanner can read the bar code

symbologies that are enabled. See 'Enable Bar Code Symbologies' for further

information.

When this option is selected, the LEDs become

visible when the trigger is pressed, and the

LEDs will immediately go off when the trigger is

released.

This is the default option for the Wasp CCD

scanner. When this option is selected, the

LEDs become visible when the trigger is

pressed, and will remain on for three (3)

seconds or until a bar code is scanned.

Tip: The delay option is a useful feature if you are scanning multiple bar codes

back-to-back. 'Trigger with 3 Sec.Delay' is the default because it is the optimal

configuration when you are setting up the Wasp CCD reader. Three bar codes

are generally scanned for each step: 'Begin', an option, and 'End'. When this

option is enabled, the trigger is typically only pressed one time to scan all three

steps.

CCD Setup & Configuration

—CCD Scanning Control Configuration

cont. on next page

*Default

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Keine Kommentare

Wasp CCD Scanner Bedienungsanleitung Seite 16